Star Jewellery Set Kit Instructions

Star Earrings Instructions:

  1. Cut the chain. Using side cutters, cut your 10 cm chain into two equal 5 cm lengths.
  2. Add the bead. Thread a star bead onto a headpin.
  3. Trim the pin. Cut the headpin so there’s ~1 cm of wire above the bead.
  4. Make a loop. Using round-nose pliers, roll the remaining wire into a neat loop right above the bead.
  5. Open the loop. With flat/chain-nose pliers, twist the loop sideways (not pulling it apart) to open it slightly.
  6. Attach the chain. Hook one 5 cm length of chain onto the loop, then twist the loop closed.
  7. Open the earwire. Gently twist open the small loop on the earwire with flat/chain-nose pliers.
  8. Attach the other end. Hook the free end of the 5 cm chain onto the earwire loop and twist it closed.
  9. Repeat. Repeat Steps 2–8 with the second headpin, bead, chain, and earwire to make the matching earring.

Tip: Always twist loops sideways to open/close; don’t pull them apart. Make sure all loops are fully closed so nothing slips off.

Star Necklace Instructions:

  1. Split the chain. Using side cutters, cut your chain into two equal halves.
  2. Add the bead. Thread the star bead onto the eyepin.
  3. Trim the pin. With side cutters, trim the pin so there’s about 1 cm of wire above the bead.
  4. Make the second loop. Using round-nose pliers, roll that 1 cm of wire into a neat loop above the bead (the eyepin now has a loop at both ends).
  5. Attach the first chain half.
    Gently twist open one eyepin loop sideways with flat/chain-nose pliers, hook on one half of the chain, then twist the loop closed.
  6. Attach the second chain half.
    Repeat Step 5 on the other eyepin loop to add the second half of the chain.

Star Bracelet Instructions:

  1. Split the chain. Using side cutters, cut your chain into two equal halves.
  2. Add the bead. Thread the star bead onto the eyepin.
  3. Trim the pin. With side cutters, trim the pin so there’s about 1 cm of wire above the bead.
  4. Make the second loop. Using round-nose pliers, roll that 1 cm of wire into a neat loop above the bead (the eyepin now has a loop at both ends).
  5. Attach the first chain half.
    Gently twist open one eyepin loop sideways with flat/chain-nose pliers, hook on one half of the chain, then twist the loop closed.
  6. Attach the second chain half.
    Repeat Step 5 on the other eyepin loop to add the second half of the chain.

Step-by-Step Video Guide

Watch the step-by-step video tutorial to create your jewellery set.

star kit yuotube.png

What Our Customers Say...