Dalmatian Jasper Bullet Bead Earrings

Dalmatian Jasper Bullet Bead Earrings

This project takes seconds to make! Perfect if you're a jewellery making beginner, looking for a quick and beautiful gift idea or a treat for yourself.

We've used our gorgeous dalmatian jasper bullet beads but you can choose from our whole range of head drilled beads. This project also features our sterling silver hoops which are also available in rose gold filled.

STEP BY STEP INSTRUCTIONS

1. Start by wire wrapping a bullet bead - click here for step by step instructions with photos of how to wire wrap a briolette. Using side cutters cut a length of wire approximately 15 - 20cm long. Slip the leaf bead onto the wire around 3-4cm down.

2. Ensuring one side of wire is longer than the other - pinch both ends of the wire together at the top of the bead to form a triangle shape and check that the bead is centered.

3. Hold both sides of the wire with your round nose pliers and bend the longer length to a right angle. At this point work half way up the plier nose to ensure you allow yourself enough room for a good wrap.

4. If necessary use side cutters to cut the short side of wire so that it stops at around the same point as bend on the longer side of wire. This will determine the length of your wrap.

5. Use your round nose pliers to form a loop with the longer side of wire by bending it to a right angle and wrapping it around the tip of the pliers. Make sure the loop is above the end of the short side of the wire and center of the briolette.

6. Hold the loop flat between the tips of your snipe nose pliers. Take the long length of wire between your fingers and holding it taught, start wrapping it around the stem of the wires - starting at the base of the loop and working down towards the bead. To help keep your wire wrapping tight you can use the tips of snipe nose pliers to gently squeeze the coil together.

7. Continue to wrap until you reach the top of the bead. You can finish your wrapping here or you can continue to wrap around the top of the bead to form a cap. Use side cutters to cut the wire as close as possible to the coil and use snipe nose pliers to squeeze the end of wire into the coil.

8. Slide on the loop to the hoop earring to dangle from the bottom.

9. Repeat the previous steps to create another hoop earring and your design is complete.


SUGGESTED TOOLS FOR THIS PROJECT

Side cutters

Round nose pliers

Pair of flat or snipe nose pliers

You may like to get our pack of pliers & side cutters which is an economical way of buying all the pliers you will need for every project!

CUSTOMISE YOUR KIT

Make the design your own by using your favourite jewellery supplies

Shop beads

Shop chain

HELPFUL PAGES

How to wire wrap a briolette bead

Read our wire wrapping advice pages with tutorials

JEWELLERY MAKING BOOKS

The Basics of Bead Stringing by Debbie Kanan

Beading Design by Kim Glover

The Encyclopedia Of Wire Jewellery Techniques by Sara Withers


Kernowcraft's jewellery making kits are aimed to inspire you - therefore the step by step instructions are available online only with a shopping list, where you can easily customise the design to suit you. We recommend printing or bookmarking this page ready to follow.

The suggested products used in this project are suggestions to inspire you. Products used were compatible at the time of making but do be aware that gemstones are natural and hand cut stocks can vary, so do use your own common sense as to the compatibility of each item when making.

Your Shopping List

You can buy all the products in this collection at once by clicking the button below or add individual products by clicking the button beside each one.

Total price for all items: £17.53


What Our Customers Say...

;