Swiss Piercing Saw Blades (Pack of 12)

Product Code: C2

from £2.05 to £3.25

£0.00(£0.00 / pack of 12)
Alternate TextSave for later

Sorry, this item is temporarily out of stock.However, you can still place your order and we will dispatch it when it becomes available. Alternatively, if you would like us to email you when this comes back into stock, enter your email address below.

Sorry, this item is temporarily out of stock.If you would like us to email you when this comes back into stock, enter your email address below.

Sorry, this item is temporarily unavailable

0   Add the first review

These high-quality A*F Gold Shark Branded Swiss made piercing saw blades are for use with a jeweller piercing saw frame. Made of hardened tempered steel with sharp, uniformly honed teeth for accurate and rapid cutting (do beware of cheaper alternatives which break much more often). They are also designed to aid detailed cutwork as the back non-cutting edge is rounded to assist in cutting tight curves. For super smooth cutting, use with beeswax as a lubricant.

  • Made of high quality hardened and tempered steel
  • A*F Swiss made Gold Shark Brand
  • Rounded back of blade makes cutting curves easier
  • Fits the majority of piercing saw frames
  • 13cm long 
  • Blank end portions allow secure clamping in the saw frame
  • Available in three grades
  • Supplied in a pack of 12

How to choose the appropriate grade saw blade:

The most appropriate grade will depend on the thickness of the metal and the nature of the job. The coarser blades are slightly thicker (and therefore stronger) so they will remove more material than fine grade. A finer blade should be used for thin metal, cutting curves or for very delicate work. We always recommend that a beginner should start with medium or coarse blades until the sawing technique is perfected as the fine ones are more liable to break. The general rule of thumb for choosing the correct coarseness of a saw blade is that there are at least 3 saw teeth in contact with the metal when sawing i.e 3 teeth per thickness of the metal sheet.

Approximate number of teeth per mm:
2/0 coarse: 2
4/0 medium: 3
6/0 fine: 4

Read our advice page on using a jewellers saw and attaching saw blades here.

No-one has reviewed this item yet. Be the first and help to advise the jewellery making community, your opinions are really valued.

Delivery Information:

UK StandardCalculated in shopping basket£2.99 - £4.99
UK Next Day Delivery*Calculated in shopping basketfrom £7.95
UK Saturday DeliveryCalculated in shopping basketfrom £14.00
EuropeCalculated in shopping basketfrom £5.95
All Other CountriesCalculated in shopping basketfrom £6.95

Click here for full delivery information & international options

*Next day deliveries for highlands & islands may take a little longer.