Spiral Pendant Necklace

Spiral Pendant Necklace

This jewellery making kit is basic and effective for a modern design. You can encase whatever you like - such as your favourite beads, a piece of sea glass or maybe a pebbles! Simply add your favourite chain to complete the look.

STEP BY STEP INSTRUCTIONS

1. Begin by creating a loop at one end of the wire using the top of the round nose pliers.

2. Next, hold the loop tight and flat with snipe or flat nose pliers and wrap around the loop in a clockwise direction. Move the pliers every few mm's keeping the circle flat. TIP: keeping the flat circle held in the snipe nose pliers will enable you to wrap the wire between the small gap of the open pliers keeping it neat and flat.

3. Continue to wrap until you have used half the wire.

4. We are aiming to create an S shape with the wire. Next, take the other end of the wire and turn over the first spiral. Again, wrap a spiral as before but this time wrap in an anti clockwise direction.

5. You should now have an S shape spiral. Use pliers to bend the wire at the centre point so the 2 spirals are now almost flat together.

6. Use pliers to hold the 2 outer rings together and gently pull out the small loop from the centre at one end creating half the round shape. Repeat at the other end.

7. Use pliers to bend back one of the small loop ends. Twist open a jump ring and thread through the loop. Catch in the chain and twist closed the jump ring.

8. Finally, insert your bead into the casing. Use pliers to adjust the shape and wire to mould nicely around your bead.

SUGGESTED TOOLS FOR THIS PROJECT

Side cutters - for cutting wire

Round nose pliers - for forming loops

Snipe nose pliers or flat nose pliers - to hold and manipulate wire

CUSTOMISE YOUR KIT

Make the design your own by customising the kit with your favourite supplies.

Shop beads

Shop chain

HELPFUL PAGES

How to open and close a jump ring


Kernowcraft's jewellery making kits are aimed to inspire you - therefore the step by step instructions are available online only with a shopping list, where you can easily customise the design to suit you. We recommend printing or bookmarking this page ready to follow.

The suggested products used in this project are suggestions to inspire you. Products used were compatible at the time of making but do be aware that gemstones are natural and hand cut stocks can vary, so do use your own common sense as to the compatibility of each item when making.


What Our Customers Say...

;