This simple bracelet is so easy to make and is a great way to use your favourite beads!
For super-fast, high strength, high quality bonds we recommend Devcon 5 minute epoxy glue.
Prepare the glue by mixing equal amounts of the resin and hardener in a small dish. Use a fine point such as a cocktail stick to dab a bit of glue onto the cap of the peg and gently place it in the half-drilled hole in the turquoise bead.
Once mixed, the glue sets in 5 minutes so ensure you set your pearl straight away. Gently place it down and leave it to set.
For full instructions plus some hints and tips on mixing and application, click here.
Using flat nose or snipe nose pliers open the 3.5mm sterling silver jump ring and loop halfway down the bracelet.
Your bracelet is now complete and ready to wear!
Devcon 5 Minute Epoxy Glue - for glueing cabochons into settings
Flat nose pliers or Snipe nose pliers
Make the design your own by using your favourite half drilled beads.
How to open and close a jump ring
The Encyclopedia of Wire Jewellery Techniques
Kernowcraft's jewellery making kits are aimed to inspire you - therefore the step by step instructions are available online only with a shopping list, where you can easily customise the design to suit you. We recommend printing or bookmarking this page ready to follow.
The suggested products used in this project are suggestions to inspire you. Products used were compatible at the time of making but do be aware that gemstones are natural and hand cut stocks can vary, so do use your own common sense as to the compatibility of each item when making.
You can buy all the products in this collection at once by clicking the button below or add individual products by clicking the button beside each one.